SATO CL 408e - Manual (Page 36)

Page 2-16
Section 2. Configuration
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
character pitch
prop fixed
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired setting.
2. Once the desired setting is underlined, press the FEED key to accept
the setting and advance to Cover Open Sensor display.
This setting allows you to set the default character pitch to either fixed character spacing
or proportional character spacing.
Character Pitch
cover open sensor
Yes No
Cover Open Sensor
This setting allows the user to enable or disable the Cover Open Sensor. Selecting YES will
enable the sensor and selecting NO will disable it.
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired setting.
2. Once the desired setting is underlined, press the FEED key to accept
the setting and return to the Advanced Mode Display.
LCD Panel — Advanced Mode
ignore cr/lf
YES NO
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to either YES or NO.
2. Once the desired setting is underlined, press the FEED key to accept
the setting and advance to the Character Pitch display.
This setting tells the printer to strip out all carriage return/line feed pairs (CRLF) from the
data stream, including graphics and 2D bar codes. It is used primarily to maintain
compatibility with earlier models of SATO printers.
Ignore CR/LF
Note: This command can be overriden by the PR or PS
Character Pitch Commands.