SATO CL 408e - Manual (Page 32)

Page 2-12
Section 2. Configuration
SATO CL408e/CL412e Service Manual PN 9001078
Rev. B
If the printer has a print job(s) loaded in memory, selecting YESwill cause the
job(s) to be cleared. The default selection is NO. Make sure that you want to
cancel the print job before selecting YES as the job cannot be recovered and will
have to be retransmitted to the printer.
To cancel the print, perform the following steps:
Cancel Print Job
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to either
No or Yes.
2. Once the correct setting is underlined, press the FEED key to accept
the setting.
3. After the print job(s) have been cleared from memory, the printer will
display a COMPLETED message for 3 seconds and then return to the
initial ONLINE Normal Mode.
If you wish to change any of the settings, you must enter the User
mode again by taking the printer OFFLINE and simultaneously
pressing FEED and LINEkeys.
cancel print job
yes no
cancel print job
COMPLETED
LCD Panel— Normal Mode