Siemens PSFR-CP41 - Manual (Page 52)

U42093-J-Z716-1-74 Operating Manual
Configuring the PSFR-CP41 Download Firmware
The following figure shows what you might see on your terminal when you
download a new revision of the firmware:
Dowloading a new revision of the firmware
Crossroads Systems CP4100 Configuration
Version: X.X
XXXX
1) Perform Configuration
2) Display Status of Power-on Self Test
3) Display Trace and Assertion History
4) Reboot
5) Download a New Revision of The Firmware
Command > 5
Download Firmware Menu
This will replace the current revision of the firmware.
A reboot will also be performed as part of this process.
Are you sure (Y/N)? y
Please begin xmodem firmware transfer ...
________ (transmit Firmware image via XMODEM)
Performing Power-on Self Test ...
(…)
Self test completed successfully
Select which mode to boot :
1. Fibre Channel/SCSI Router
2. Diagnostics Monitor
seconds left 1 : 1
Verifying firmware checksum ...
Updating firmware ...
Target Name: Crosspoint
Attaching network interface lnPci0... done.
Attaching network interface lo0... done.
NFS client support not included.
Initializing sioc...
SCRIPTS start @ 0x88002000 (3520)
BRIDGE: Bridge Timed out SCSI Req on bus 0 target 0 lun 0. Check ca
Initialized Successfully
Build Level: XXXX