Siemens PSFR-CP41 - Manual (Page 38)

U42093-J-Z716-1-74 Operating Manual
Configuring the PSFR-CP41
The PSFR-CP41 uses a menu structure to configure the PSFR-CP41 through
the serial and telnet interfaces. The currently selected menu and the firmware
version currently executing will be displayed. Menu items are selected by
entering the number of the menu desired, and exited by entering an ‘X’. In
general, the configuration options present in the serial interface correspond to
those available through SNMP and telnet.
Menus are not case sensitive. You can enter uppercase and lowercase
characters interchangeably when selecting from menus.
The PSFR-CP41 Configuration Program allows the user to control many config-
uration settings through the PSFR-CP41 serial interface. Among these are:
Baud rate of the serial port
Fibre Channel address
SCSI initiator and target IDs
Ethernet IP and MAC addresses
Fibre Channel-to-SCSI mapping
SCSI-to-Fibre Channel mapping
Trace level settings
Configuration settings may be changed and saved.
Unless otherwise indicated, all configuration options set do not take
effect until the next boot cycle of the PSFR-CP41 unit.
i
i