Star Micronics Dot Impact Printer - Manual (Page 79)

3-71 STAR Command Specifications
Rev. 0.70
ESC # N m n1 n2 n3 n4 LF NUL
[Name] Set memory switch
[Code] ASCII ESC # N m n1 n2 n3 n4 LF NUL
Hexadecimal 1B 23 N m n1 n2 n3 n4 0A 00
Decimal 27 35 N m n1 n2 n3 n4 10 0
[Defined Area] m = 44, 43, 45 (m = “,”, “+”, “-“)
48 ≤ N ≤ 57 (”0” ≤ N ≤ “9”), 65 ≤ N ≤ 70 (”A” ≤ N ≤ “F”)
48 ≤ n1 ≤ 57 (”0” ≤ n1 ≤ “9”), 65 ≤ n1 ≤ 70 (”A” ≤ n1 ≤ “F”)
48 ≤ n2 ≤ 57 (”0” ≤ n2 ≤ “9”), 65 ≤ n2 ≤ 70 (”A” ≤ n2 ≤ “F”)
48 ≤ n3 ≤ 57 (”0” ≤ n3 ≤ “9”), 65 ≤ n3 ≤ 70 (”A” ≤ n3 ≤ “F”)
48 ≤ n4 ≤ 57 (”0” ≤ n4 ≤ “9”), 65 ≤ n4 ≤ 70 (”A” ≤ n4 ≤ “F”)
[Initial Value] ---
[Function] Sends command to write after defining memory switch using the definition command specified by the
following classes.
This command is set only and not changed for the current operating environment.
Changed settings are valid after the power is turned on again, or when the printer is reset.
Consider the life of the non-volatile memory and avoid over-sue of this command.
Function Class m N n1 n2 n3 n4
Data Definition (Data Specification) Definition “,” N n1 n2 n3 n4
Data definition (set specified bit) Definition “+” N n1 n2 n3 n4
Data definition (clear specified bit) Definition “-” N n1 n2 n3 n4
• m: Mode Selection
• N: Memory switch number to specify
• n1 n2 n3 n4: Setting Data m = “,” → Specified data
m = “+” → Bit number to set
m = “-” → Bit number to clear
Note The status of this command varies according to the model, so check the special appendix.