Star Micronics Dot Impact Printer - Manual (Page 32)

3-24 STAR Command Specifications
Rev. 0.70
ESC C n
[Name] Set page length to n lines
[Code] ASCII ESC C n
Hexadecimal 1B 43 n
Decimal 27 67 n
[Defined Area] 1 ≤ n ≤ 255
[Initial Value] 1/6 inch x 42
[Function] This command sets the length of one page to [currently set line feed amount x n] lines
The current position is the top position of the page.
The page length set using this command is unaffected by changing the form feed amount later.
Moving to the top of the page is performed using the FF (form feed) command.
If a page length is set less than the bottom margin setting value that is currently set, the page length setting
value is valid and the bottom margin setting value is cleared.
ESC C NUL n
[Name] Set page length to n inches
[Code] ASCII ESC C NUL n
Hexadecimal 1B 43 00 n
Decimal 27 67 0 n
[Defined Area] 1 ≤ n ≤ 127
[Initial Value] n = 7
[Function] This command sets the length of one page to n inches.The current position is the top position of the page.
The page length set using this command is unaffected by changing the form feed amount later.
Moving to the top of the page is performed using the FF (form feed) command.
If a page length is set less than the bottom margin setting value that is currently set, the page length setting
value is valid and the bottom margin setting value is cleared.