Star Micronics Dot Impact Printer - Manual (Page 31)

3-23 STAR Command Specifications
Rev. 0.70
3-3-5 Page Control Commands
FF
[Name] Form feed
[Code]
ASCII FF
Hexadecimal 0C
Decimal 12
[Defined Area] ---
[Initial Value] ---
[Function] This command performs the following operations after the printer prints the printing data in the line buffer.
Operations are set by the memory switch.
Memory SW Cutter Model Tear Bar Model
Condition (1) Executes a form feed Executes a form feed.
Condition (2) Feeds paper to the cutting position and performs a full cut. (*1) Paper is fed to the tear-bar position. (*2)
Condition (3) Executes a form feed. Executes a form feed.
Condition (4) Feeds paper to the cutting position and performs a partial cut. (*1) Paper is fed to the tear-bar position. (*2)
(*1) Paper feed to cutting position: Executes a 1 inch paper feed.
(*2) Paper feed to tear-bar position: Executes a 7/6 inch paper feed.
See each printer's product specifications manual for details on the memory switch settings.