Star Micronics Dot Impact Printer - Manual (Page 71)

3-63 STAR Command Specifications
Rev. 0.70
ESC u 1
[Name] Specify 16 x 16 dot [single density] Kanji characters.
[Code] ASCII ESC u 1 Or ESC u “1”
Hexadecimal 1B 75 01 1B 75 31
Decimal 27 117 1 27 117 149
[Defined Area] ---
[Initial Value] Specify two-byte 16 x 16 dot (single density) Kanji characters.
[Function] Specify 16 x 16 dot [single density] Kanji characters.
When two-bytes is selected, they become two-pass characters (state (B) to state (A))Dots continuous
horizontally are thinned for printing.
This command sets to the double-tall expanded character mode by combining with ESC x 0 (Specify
expanded Kanji characters) (state (B) → state (C))
See “Relationship of Kanji Character Size Selection.”
ESC u 0
[Name] Specify 16 x 16 dot [Double Density] Kanji characters
[Code] ASCII ESC u 0 Or ESC u “0”
Hexadecimal 1B 75 00 1B 75 30
Decimal 27 117 0 27 117 148
[Defined Area] ---
[Initial Value] Specify two-byte 16 x 16 dot (single density) Kanji characters.
[Function] Specify 16 x 16 dot [double density] Kanji characters.
When two-bytes is selected, they become four-pass characters (state (A) to state (B))Dots continuous
horizontally are printing.
This command sets to the 4 x expanded character mode by combining with ESC x 0 (Specify expanded Kanji
characters) (state (A) → state (D))
See “Relationship of Kanji Character Size Selection.”