Star Micronics Dot Impact Printer - Manual (Page 57)

3-49 STAR Command Specifications
Rev. 0.70
3-3-12 External Device Drive
ESC BEL n1 n2
[Name] Set external drive device 1 pulse width
[Code] ASCII ESC BEL n1 n2
Hexadecimal 1B 07 n1 n2
Decimal 27 7 n1 n2
[Defined Area] 1 ≤ n1 ≤ 127
1 ≤ n2 ≤ 127
[Initial Value] n1 = 20 (Energizing time: 200 msec)
n2 = 20 (Delay time: 200 msec)
[Function] Sets the energizing and delay times for drive of the external device (such as cash drawers).
• Energizing time = 10 x n1 (ms)
• Delay time = 10 x n2 (ms)
After printing, this is executed by BEL (External device 1 drive instruction) or FS (External device 1 drive
instruction (real time)).
Handled in the following way when n1 and n2 are out of range.
• When n1 = 0, or n2 = 0, this command is ingored.
• When n1 > 128, n = 128, when n2 > 128, n = 128.
10 x n2 (msec) 10 x n1 (msec)
Prohibit Printing, Paper Feed
(Energize Time) (Delay Time)
OFF
ON
Drive Pulse
Print Operation