Star Micronics Dot Impact Printer - Manual (Page 59)

3-51 STAR Command Specifications
Rev. 0.70
SUB
[Name] External device 2 drive instruction (real time)
[Code] ASCII SUB
Hexadecimal 1A
Decimal 26
[Defined Area] ---
[Initial Value] ---
[Function] Drives external device 2.The energizing time and delay time are fixed at 200 ms each.
The printer executes this command immediately upon reception.
This command is the same as the EM command.
Note External device 1 and external device 2 cannot be executed simultaneously.
This command is executed in real time only, so even if executed continuously, the drive
occurs only once.
EM
[Name] External device 2 drive instruction (real time)
[Code] ASCII EM
Hexadecimal 19
Decimal 25
[Defined Area] ---
[Initial Value] ---
[Function] Drives external device 2.The energizing time and delay time are fixed at 200 ms each.
The printer executes this command immediately upon reception.
This command is the same as the SUB command.
Note External device 1 and external device 2 cannot be executed simultaneously.
This command is executed in real time only, so even if executed continuously, the drive
occurs only once.