Juniper Networks SSG 20 - Manual (Page 82)

SSG 20 Hardware Installation and Configuration Guide
82 „
Table 27: Fields in Wireless0/0 Interface Window
14. Interface Summary Window
After you have configured the WAN interfaces, you will see the Interface Summary
window.
Figure 43: Interface Summary Window
Field Description
Wlan Mode Sets the WLAN radio mode:
„ 5G (802.11a).
„ 2.4G (802.11b/g).
„ Both (802.11a/b/g).
SSID Sets the SSID name.
Authentication and Encryption Sets the WLAN interface authentication and encryption:
„ Open authentication, the default, allows anyone to access
the device. There is no encryption for this authentication
option.
„ WPA Pre-Shared Key authentication sets the Pre-Shared Key
(PSK) or passphrase that must be entered when accessing a
wireless connection. You can choose to enter a HEX or an
ASCII value for the PSK. A HEX PSK must be a 256-bit
(64-text character) HEX value. An ASCII passphrase must be
8 to 63 text characters. You must select Temporal Key
Integrity Protocol (TKIP) or Advanced Encryption Standard
(AES) as the encryption type for this option, or select Auto to
allow either option.
„ WPA2 Pre-Shared Key.
„ WPA Auto Pre-Shared Key.
Interface IP Sets the WLAN interface IP address.
Netmask Sets the WLAN interface netmask.