Juniper Networks SSG 20 User Manual
Page 76
SSG 20 Hardware Installation and Configuration Guide
76
Table 21: Fields in ISDN Physical Layer Tab Window
You can select the bri1/0 interface to connect using dialer, multi-link dialer, leased
line, or dial with BRI. Selecting neither, one, or both options displays a window
similar to the following.
Field
Description
Switch Type
Sets the service provider switch type:
att5e: At&T 5ESS
ntdms100: Nortel DMS 100
ins-net: NTT INS-Net
etsi: European variants
ni1: National ISDN-1
SPID1
Service Provider ID, usually a seven-digit telephone number with
some optional numbers. Only the DMS-100 and NI1 switch
types require SPIDs. The DMS-100 switch type has two SPIDs
assigned, one for each B-channel.
SPID2
Backup service provider ID.
TEI Negotiation
Specifies when to negotiate TEI, either at startup or on the first
call. Typically this setting is used for ISDN service offerings in
Europe and connections to DMS-100 switches that are designed
to initiate TEI negotiation.
Calling Number
ISDN network billing number.
Sending Complete checkbox
Enables sending of complete information to outgoing setup
message. Usually only used in Hong Kong and Taiwan.