Juniper Networks SSG 20 - Manual (Page 78)

SSG 20 Hardware Installation and Configuration Guide
78 „
9. V.92 Modem Interface Window
If you have the V.92 mini-PIM installed in your device, you can configure the
serialx/0 (Modem) interface using the following window:
Figure 38: Modem Interface Window
Table 23: Fields in Modem Interface Window
10. Eth0/0 Interface (Untrust Zone) Window
The eth0/0 interface can have a static or a dynamic IP address assigned via DHCP
or PPPoE.
Dialer Pool (Dialer only) Sets the dialer pool name for the dialer interface.
Netmask Sets the netmask.
Gateway Sets the gateway address.
Field Description
Modem Name Sets the name for the modem interface
Init String Sets the initialization string for the modem
ISP Name Assigns a name to the service provider
Primary Number Specifies the phone number to access the service provider
Alternative Number (optional) Specifies an alternative phone number to access the service
provider if the primary number does not connect
Login Name Sets the login name for the service provider account
Password Sets the password for the login name
Confirm Confirms the password typed in the Password field
Field Description