Juniper Networks SSG 20 - Manual (Page 30)

SSG 20 Hardware Installation and Configuration Guide
30 „ Accessing a Device
Figure 14: WebUI Login Prompt
4. If you have not yet changed the default login for the admin name and
password, enter
netscreen at both the admin name and password prompts.
(Use lowercase letters only. The login and password fields are both
case-sensitive.)
Using Telnet
To establish a Telnet connection, perform the following steps:
1. Connect your workstation to the 0/2 — 0/4 port (bgroup0 interface in the Trust
zone) on the device.
2. Ensure that your workstation is configured for DHCP or is statically configured
with an IP address in the 192.168.1.0/24 subnet.
3. Start a Telnet client application to the IP address for the bgroup0 interface (the
default IP address is 192.168.1.1). For example, enter
telnet 192.168.1.1 .
The Telnet application displays the login prompt.
4. If you have not yet changed the default login for the login and password, enter
netscreen at both the login and password prompts. (Use lowercase letters only.
The login and password fields are both case-sensitive.)
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To remove the timeout, enter
set console timeout 0 .