Juniper Networks SSG 20 - Manual (Page 19)

„ 19
Chapter 2
Installing and Connecting the Device
This chapter describes how to mount an SSG 20 device and connect cables and
power to the device. This chapter contains the following sections:
„ “Before You Begin” on page 20
„ “Installing Equipment” on page 20
„ “Connecting Interface Cables to a Device” on page 22
„ “Connecting the Power” on page 22
„ “Connecting a Device to a Network” on page 23
NOTE:
For safety warnings and instructions, refer to the Juniper Networks Security
Products Safety Guide. Before working on any equipment, you should be aware of
the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents.