JVC VN-C205 User Manual
Page 43
43
2
Relay Alarm
• Alarm Output
• Message Packet
• Alarm FTP
• Shutdown
3
Retry (1 to 3)
Item
Function/Set Value
Set here to enable the relay alarm function, which is activated
when 2 alarms are received within a preset time interval.
The sequence and time interval for the alarm input can be specified.
When [Alarm Output] is selected, alarm signal output will be
sent to the alarm output terminal on the ceiling mount accord-
ing to the output port settings.
* Please refer to the [Alarm 1/2] item for details on the set val-
ues.
For setting the no. of times alarm notification is to be sent to
the "V.Networks Controller". (Set Value: 1 to 3)
Initial Value
Not Available
*Please
refer to
the [Alarm
1/2] item
for the
initial
values.
1
Note
• Alarm notification may fail, depending on the LAN
environment in use. If it fails, set the value for alarm
notification to "3". In this case, alarm by the "V.Networks
Controller" itself is set off only once.
Notes
• A second alarm input enables this relay alarm function,
and alarm will not be activated for this second input.
• Unless the alarm output in the "Alarm Output" tab is
enabled, this function will not be activated even if alarm
output is selected in the alarm input settings. (
Press here to display the IP address of the PCs to which an
alarm notification is sent. ("Distribution Address List" Screen)
To delete a distribution address, select the IP address to de-
lete, followed by pressing the Delete button.
—
4
List
Notes
• The list allows setting of up to 10 addresses.
• Message packets will not be sent out when there are 11 or
more addresses.
C205_p27-45
05.6.28, 11:45 AM
43