beautypg.com

JVC VN-C205 User Manual

Page 32

background image

32

2-3 Setting IP Address for this Camera Using the "VN-C205U Setup Tool"

Settings (Step 2 Network Settings)

Set the IP address for VN-C205 using the "VN-C205U Setup Tool" that has been installed.

(This "VN-C205U Setup Tool" only allows connection of VN-C205.)

1.

Select [Start] [Programs] [V.NETWORKS]

[VN-C205U Setup Tool] to start

up the "VN-C205U Setup Tool".

The [V.Networks Search] screen is

displayed.

Click

to start search and

a [V.Networks IP Address List] will
appear.

• [TimeOut] is for setting the time for searching (1 to 30 seconds). If no IP address is displayed

upon searching, change the value to a longer time and search again.

• If the [V.Networks] on the LAN has a different subnet from that of the PC, connection may not

be possible even if the IP address of the camera is found via search. Change the IP address
of the PC to an appropriate value and connect the camera.

1

Enter the IP address of the camera to be

connected in [Connection IP address].

Default IP address is 192.168.0.2.

2

Click

.

Notes

To view the IP address of the connected camera, click "Search".

Note

To connect to a VN-C205 for which DHCP has been enabled, the DHCP server must exist in an
environment where the assigned IP address and MAC address are clearly defined. If the DHCP
server is not found, it will automatically start up using the static IP address after 60 seconds.

Cautions

• Upon turning on the power of this camera, it may take about 60 seconds before it can be

connected to the PC.

• At the factory, DHCP is enabled for VN-C205.

• Using DHCP

JVC does not recommend operating VN-C205 with the DHCP function enabled because a
different IP address may be assigned upon the renewal of the leasing contract. The DHCP
function of VN-C205 is included with the aim to simplify installation/setting procedures.

C205_p27-45

05.6.28, 11:45 AM

32