JVC VN-C205 - Manual (Page 16)

16
1.
Open a hole in the ceiling.
Use the template and open a hole in the ceiling
for the cables.
2.
Pull out the cables from the ceiling.
Before connecting, pull out the input power
cable and video signal cables about 100 mm
(3-7/8 inches) from the ceiling.
3.
Attach the safety cable to the camera.
(Safety cable is not included)
Attach the safety cable to the back of the
camera.
1-2 Mounting the Camera to the Ceiling
1. Preparations
Note
There is no need to open a hole in the
ceiling when using the cable extraction
hole on the side of the camera.
(
☞
Refer to step 4. on page 17)
Cautions
● Attachment of a embedded cover in the
ceiling (recess bracket) may be mandatory
in certain regions. If this is so, ensure that
the embedded cover (recess bracket) is
securely attached before installing the
camera.
● Please refer to the instruction manual for the
cover in use for details on installation of the
embedded cover (recess bracket).
● For more detail, please contact the JVC.
Embedded Cover in Ceiling (recess bracket)
Ceiling
Open hole in ceiling, connect cables and mount camera to ceiling.
Cautions
● To avoid unforeseen accidents, attach the
safety cable.
● Select a suitable safety cable based on
length, strength, location, material
(insulation property), etc.
● Always use the M2.6 x 6 screws mounted
on the unit.
(3/4 inches)
(3-7/8 inches)
20 mm
Approx.100 mm
Video signal
cable
Input power
cable
Alarm signal
cable
LAN cable
1.
2.
3.
Safety cable
Preparation (Step 1 Connection/Installation)
C205_p2-26 05.7.4, 0:58 PM 16