JVC VN-C205 - Manual (Page 20)

20
Preparation (Step 1 Connection/Installation)
1-2 Mounting the Camera to the Ceiling (Continued)
2. Installation
Note
When using 100 BASE-TX, ensure to use
a Category 5 (or higher) cable.
Caution
The use of a crossover cable may not be
supported by certain LAN boards on some
rare occasions. As such, please check your
LAN board specifications before connection.
1.
Attach the safety cable to the ceiling
slab. (Safety cable not included)
Attach the safety cable that has already been
attached to the camera to the ceiling slab or
channel. Make sure that the wire is attached
securely.
2.
Connect the video signal cable.
Connect the coaxial cables (BNC) to the video
signal output connector (BNC).
Safety
cable
Video signal
cable
Attach to ceiling slab
Insulation tape
Input power supply
cable
Solder or
crimp 5.
1.
2 .
4 .
3 .
Alarm signal cable
LAN cable
Alarm Signal Cable
10 BASE -T/100 BASE-TX
Terminal
LAN cable
Cable
Maximum length (No
cable compensator)
RG-59 200m (650 ft)
RG-6 350m (1140 ft)
RG-11 450m (1470 ft)
4.
Connect the alarm terminal
Connect the alarm cable wired in step 5 of
Preparations (
☞
page 17) to the alarm
terminal of camera unit. Pass the cable under
the plate for depressing cables same as step
3 before connecting.
5.
Connect the input power supply cable.
Connect the cable protruding from the ceiling
to the input power cable. (
☞
Page 22)
3.
Connect the LAN cable
Pass the LAN cable coming out from the
ceiling under the plate for depressing cables,
connect it to the 10BASE-T/100BASE-TX
Terminal of the camera unit.
Note
The input power cable uses materials
similar to those of machinery wiring, so
wrap the cable with insulation tape to
prevent it from becoming damaged when
mounting the camera.
Use durable wiring for the input power
cable.
C205_p2-26 05.7.4, 0:58 PM 20