FI ( * 9 8 ! # $ % 0 – JVC VN-C205 User Manual
Page 10
10
Name and Function of Parts (Continued)
Body Surface
View when the dome cover is removed.
For instructions on removing the dome cover, see step 4 of “Mounting the Camera to the Ceiling”.
(
Introduction
8
Head
For adjusting the lens, focus, or camera angle.
9
Tilt lock screws
Use when adjusting the angle of view of the
camera. (
0
[IRIS LEVEL] Iris level adjustment
For adjusting the level of the automatic aper-
ture control lens. This adjustment only needs
to be made when required. Use this to accom-
modate particular shooting conditions.
!
MONITOR terminal (RCA pin)
For connecting a monitor when mounting the
camera for adjusting the lens or determining
the camera angle. (High impedance)
@
Wire clamp
When pulling out the cables from the side of
camera unit without opening a hole on the
ceiling, arrange the all the cables by bundling
them into this wire clamp.
#
[ALARM IN/OUT] Alarm Input/Output
Terminals
Terminals for alarm input and output.
(
$
CF card Slot
Insert the CF card. (
&
^
)
¤
fi
(
*
9
8
!
# $
%
0
@
⁄
‹
›
Video setting switch
Turning direction of level
To darken image
Counterclockwise (L side)
To brighten image Clockwise (H side)
Note
● When adjusting the iris level, set the
AGC switch to “OFF”. Otherwise, when
the level is turned too far toward L, the
AGC function activates increasing
sensitivity and the picture may look
uneven.
C205_p2-26
05.7.4, 0:57 PM
10