JVC HM-HDS1U - Manual (Page 49)

EN
49
RECORDING FEATURES for VHS deck
Record One Program While
Watching Another
Recording
Features
ENGAGE TV MODE
1
During recording...
● Change the TV's input mode from AV to TV.
SELECT CHANNEL FOR
VIEWING
2
Use the TV’s channel selector to set the channel you
want to watch.
RESET COUNTER TO ZERO
1
Before recording starts, press C.RESET. The counter
resets to zero and displays the exact elapsed time as the
tape runs.
DISPLAY ELAPSED TIME ON
SCREEN
2
During recording, press OSD at any time to see the
elapsed time.
All indications corresponding to the current status of the
recorder are displayed for 5 seconds. The counter
display remains on the screen indicating the elapsed
time. Press OSD again to remove the display.
● Make sure “SUPERIMPOSE” is set to “ON“ ( ੬
pg.
41).
● The indications are not recorded.
● Press OSD to change to the COUNT display if
“REMAIN” is displayed.
Display Elapsed Recording
Time
Display Tape Remaining Time
(VHS deck only)
DISPLAY COUNTER
INFORMATION
1
Press OSD.
All indications corresponding to the recorder’s current
status are displayed for 5 seconds. The counter display
remains on the screen indicating the elapsed time.
DISPLAY TAPE REMAINING
TIME
2
Press OSD repeatedly until “REMAIN” appears on
screen. The approximate tape remaining time appears
on the TV screen and also on the recorder display panel
with a "
" indicator.
● The tape remaining time is calculated based on the
tape speed (SP or EP) being used. The indicated
remaining time is only an estimate.
● Press OSD to change the on-screen display from
“REMAIN” to “COUNT” and vice versa; and to show
counter reading, channel number, clock time or tape
remaining time on the front display panel. Then
channel number will not be displayed when the
recorder is playing a tape.
EXIT THE DISPLAY
3
Press OSD again.
NOTES:
● “SUPERIMPOSE” must be set to “ON”, or the on-screen
display will not appear (
੬
pg. 41).
● Near the beginning of the tape, the tape remaining estimate
may be inaccurate. However, the estimate becomes more
accurate as the tape comes closer to the end.
● Depending on the type of tape used, the tape remaining time
reading may not appear right away, or may not be correct. "- -:- -"
may sometimes appear, or the display may blink on occasion.
● The tape remaining time indication is not accurate when
using VHS-C tapes with VHS-C adapter.
1 2 3
4 5 6
7 8 9
0
2
1
4
3
> <
1
2
– +
C.RESET
OSD