JVC XM-PJ1BU - Manual

PORTABLE MINIDISC PLAYER
ENGLISH
LVT0122-001A [E]
XM-PJ1BU
Remove the rechargeable battery from its case before use.
Use numbers indicated in parentheses when asking for replacement parts.
AC adaptor (AA-R9017) 1 pc.
Headphones 1 pc.
Wired remote control 1 pc.
Charger/adaptor (AC-R124) 1 pc.
Supplied Accessories
Check the packing carton for these accessories.
Thank you for purchasing this JVC product. Please read these instructions carefully before starting operation to be sure to obtain opti-
mum performance and a longer service life from the unit.
INSTRUCTIONS
Nickel metal hydride battery (rechargeable) (BN-R127) 1 pc.
Carrying pouch 1 pc.
Power Supply Preparations
Refer to the specifications for information on operating times when using rechargeable battery,
dry-cell battery, or both together.
Using nickel metal hydride battery (rechargeable
battery) (BN-R127)
1 Remove the supplied rechargeable battery from its case.
2 Insert the rechargeable battery into the supplied charger/adaptor.
3 Set the switch of the charger/adaptor to “CHARGER”.
4 Connect the supplied AC adaptor.
5 The charge indicator lights in red and it will go out when recharging
is completed. Unplug the AC adaptor from the AC outlet and the charger/
adaptor.
6 Remove the recharged battery from the charger /adaptor and insert
it into the unit.
Position the ribbon under the battery in order to easily remove the battery from the case.
Notes:
• You cannot use the MD player during charging the rechargeable battery.
• It takes approximately 1.5 hours to recharge the rechargeable batteries.
• Rechargeable battery has a service life of approximately 300 charge-discharge cycles. If the
operating time on one full charge becomes noticeably shorter than it used to be, the battery
has reached the end of its service life and should be replaced.
• The AC adaptor and rechargeable batteries may become warm while recharging is in
progress. This is not a malfunction.
Using the AC adaptor
CAUTION: Be sure no battery is inserted into the unit.
1 Set the switch of the charger/adaptor to “ADAPTOR”.
2 Connect the supplied AC adaptor and charger/adaptor.
Note:
The unit is in the standby condition when the AC adaptor and charger/adaptor are connected.
The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet.
Using dry-cell battery (not included)
CAUTION: Do not use the dry-cell battery together with the AC adaptor.
Open the battery cover and insert a LR6 (UM-3) alkaline battery into the battery compartment.
Position the ribbon under
the battery in order to eas-
ily remove the battery from
the case.
Note:
To lengthen the battery life, you can use both rechargeable battery and the dry-cell battery.
Cautions
Unit
No altering or remodeling
This can cause malfunctioning.
No dropping or strong impacts
This may damage the unit.
Locations to be avoided
Avoid using the unit in the following locations since they can cause malfunctioning.
1. Bathrooms and other moisture-prone places.
2. Warehouses and other dusty places
3. Very hot places near heating appliances, etc.
Do not leave the unit exposed to direct sunlight for long periods of time
This may deform or discolor the cabinet and may also cause malfunctioning.
Precautions for Listening with the headphones
• Do not play your headset at a high volume. Hearing experts advise against continuous ex-
tended play.
• If you experience a ringing in your ears, reduce volume or discontinue use.
• Do not use while operating a motorized vehicle. It may create traffic hazard and is illegal in
many areas.
• You should use extreme caution or temporarily discontinue use in potentially hazardous
situations.
• Even if your headphones are an open-air type designed to let you hear outside sounds, don’t
turn up the volume so high that you can’t hear what’s around you.
When driving a car
In the interest of traffic safety, do not operate the unit while driving.
Batteries
• Before replacing batteries, always turn off the unit.
Rechargeable nickel metal hydride battery (BN-R127):
• Use only the rechargeable battery (BN-R127) supplied with the unit.
• If the power delivered by the battery lasts for a very short time after recharging, it means
that the battery’s service life is over. Do not use it any more.
• Recharging already charged battery will shorten its service life.
• When recharging battery for the first time or when it has not been used for a long period of
time, the play time may be shorter than usual. In a case like this, repeatedly recharge and
discharge the battery. This will restore it to its regular state.
• Do not allow any metal objects to touch the terminals of rechargeable battery since this may
cause short-circuiting which is dangerous.
• Recharging shall be made at the temperature from 10°C to 35°C.
Dry cell battery and rechargeable battery:
To prevent damage to the batteries and electrolyte leakage, heed the following points.
• Align the » and Æ polarities properly when inserting the batteries.
• Remove the batteries if you do not plan to use the unit for a long period of time.
• Do not throw batteries into a fire, and do not short-circuit, disassemble or subject them to
excessive heat.
• Do not attempt to recharge dry cell batteries.
Carrying batteries:
When putting dry cell or rechargeable batteries in a pocket or bag, ensure that no other metal
objects such as a necklace are placed together with them. Contact with metal may cause short-
circuiting which, in turn, may cause a fire.
Be absolutely sure to carry the rechargeable battery in the battery carrying case.
Notice about the rechargeable battery
The battery is designated recyclable.
Please follow your local recycling regulations.
AC adaptor and charger/adaptor
• Handle the AC adaptor and charger/adaptor carefully. Improper handling is dangerous.
• Do not touch them with wet hands.
• Do not place heavy objects on top of them.
• Do not forcibly bend them.
• Be sure to connect only the AC adaptor and charger/adaptor provided with the unit.
• Disconnect the AC adaptor from the power outlet if the unit is not going to be used for a
long time.
A HOLD switch
B Headphones jack ( )
C Play / pause / stop button ( 38 / 7 )
D EJECT button
E Skip / search button ( ¢ )
F Skip / search button ( 4 )
G Volume +, – button
H HOLD switch
I Display
Location of Controls
J DISPLAY button
K Play / pause /stop button ( 38 / 7 )
L FAV (Favorite) button
M JOG dial
Volume +, – & Skip / search button
( 4 ¢ )
N JOG MODE button
O A.C.BASS (Active Clear Bass) but-
ton
P P.MODE (Play Mode) button
[Indicators on the display
of the remote control]
AC adaptor
Charge indicator
Charger/Adaptor
Charger/Adaptor
AC adaptor
HOLD
Top panel of the remote control
Bottom of the unit
EJECT
PORTABLE MINIDISC PLAYER XM-PJ 1
LOCK
VOLUME
VOL
JOG
MODE
A.C.BASS
Disc mark
BASS
Random
MONO
Battery
Repeat FAV
Rechargeable battery (BN-R127) BN-R127
Charger/Adaptor
Accidental Operation Prevention Function (Hold
Mode)
This function prevents the unit from accidental button operation.
The unit and remote control have the HOLD switches, each of which works independently.
Slide the HOLD switch in the direction shown by the arrow to activate it.
When the HOLD switch of the unit or remote control is activated, no button operation is pos-
sible in the unit or the remote control.
To operate the unit or remote control normally
, return the HOLD switch.
Accidental Opening Prevention Function
To prevent the lid from the accidental opening, turn the EJECT button to the right in order to
lock it.
Battery Indicator
The battery indicator appears on the display of the remote control. When the indication
changes as follows, power will be shut off a short while after.
Rechargeable battery: Recharge it.
Dry-cell batter y: Replace it with new one.
Notes:
• The battery indicator appears when an MD is loaded in the unit.
• The battery indicator also appears when the AC adaptor is used. However, it has no mean-
ing.
Insert the battery . Slide the cover slightly
upward, then close it.
OPEN
OPEN
BN-R127
Ribbon
Open the battery cover.
Alkaline battery (Not supplied)
Ribbon
EJECT
LOCK
• To open the lid, return the EJECT button to the original
position and then press it.
• It is recommended to lock the lid when moving the bat-
teries.
WARNING LABEL,
PLACED INSIDE
THE UNIT
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR
YOURSELF. REFER SERVICING TO QUALIFIED
PERSONNEL.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
CLASS 1
LASER PRODUCT
1. CLASS 1 LASER PRODUCT
2. DANGER: Invisible laser radiation
when open and interlock failed or
defeated. Avoid direct exposure to
beam.
3. CAUTION: Do not open the top cover.
There are no user serviceable parts
inside the Unit; leave all servicing to
qualified service personnel.