Using ping, Understanding ping, Executing ping – IBM 12.1(22)EA6 User Manual
Page 474
25-8
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 25 Troubleshooting
Diagnosing Connectivity Problems
Using Ping
This section consists of this information:
•
•
Understanding Ping
The switch supports IP ping, which you can use to test connectivity to remote hosts. Ping sends an echo
request packet to an address and waits for a reply. Ping returns one of these responses:
•
Normal response—The normal response (hostname is alive) occurs in 1 to 10 seconds, depending
on network traffic.
•
Destination does not respond—If the host does not respond, a no-answer message is returned.
•
Unknown host—If the host does not exist, an unknown host message is returned.
•
Destination unreachable—If the default gateway cannot reach the specified network, a
destination-unreachable message is returned.
•
Network or host unreachable—If there is no entry in the route table for the host or network, a
network or host unreachable message is returned.
Executing Ping
If you attempt to ping a host in a different IP subnetwork, you must define a static route to the network.
Beginning in privileged EXEC mode, use this command to ping another device on the network from the
switch:
Note
Though other protocol keywords are available with the ping command, they are not supported in this
release.
This example shows how to ping an IP host:
Switch# ping 172.20.52.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echoes to 172.20.52.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
Switch#
Command
Purpose
ping [ip] {host | address}
Ping a remote host through IP or by supplying the host name or
network address.