IBM 12.1(22)EA6 User Manual
Page 379
21-11
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 21 Configuring SNMP
Configuring SNMP
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
.
Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs
to a host:
entity
Generates a trap for SNMP entity changes.
envmon
Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, status, supply, temperature.
flash
Generates SNMP FLASH notifications.
hsrp
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
mac-notification
Generates a trap for MAC address notifications.
port-security
Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
rtr
Generates a trap for the SNMP Response Time Reporter (RTR).
snmp
Generates a trap for SNMP-type notifications.
stpx
Generates SNMP STP Extended MIB traps.
syslog
Generates SNMP syslog traps.
tty
Generates a trap for TCP connections. This trap is enabled by default.
vlancreate
Generates SNMP VLAN-created traps.
vlandelete
Generates SNMP VLAN-deleted traps.
vlan-membership
Generates a trap for SNMP VLAN membership changes.
vtp
Generates a trap for VLAN Trunking Protocol (VTP) changes.
Table 21-4
Switch Notification Types (continued)
Notification Type
Keyword
Description
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
snmp-server engineID remote
ip-address engineid-string
Specify the engine ID for the remote host.
Step 3
snmp-server user username
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
Configure an SNMP user to be associated with the remote host created in
Step 2.
Note
You cannot configure a remote user for an address without first
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
Step 4
snmp-server group [groupname {v1 |
v2c | v3 {auth | noauth | priv}}] [read
readview] [write writeview] [notify
notifyview] [access access-list]
Configure an SNMP group.