IBM 12.1(22)EA6 - Manual (Page 343)

18-11
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 18 Configuring SPAN and RSPAN
Configuring SPAN
Removing Ports from a SPAN Session
Beginning in privileged EXEC mode, follow these steps to remove a port as a SPAN source for a session:
To remove a source or destination port from the SPAN session, use the no monitor session
session_number source interface interface-id global configuration command or the no monitor session
session_number destination interface interface-id global configuration command. To change the
encapsulation type back to the default (native), use the monitor session session_number destination
interface interface-id without the encapsulation keyword.
This example shows how to remove a port as a SPAN source for SPAN session 1:
Switch(config)# no monitor session 1 source interface gigabitethernet0/17
Switch(config)# end
This example shows how to disable received traffic monitoring on a port that was configured for
bidirectional monitoring:
Switch(config)# no monitor session 1 source interface gigabitethernet0/17 rx
The monitoring of traffic received on port 1 is disabled, but traffic sent from this port continues to be
monitored.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 no monitor session session_number source
interface interface-id [, | -] [both | rx | tx] Specify the characteristics of the source port (monitored port) and
SPAN session to remove.
For session, specify 1.
For interface-id, specify the source port to no longer monitor. Valid
interfaces include physical interfaces and port-channel logical
interfaces (port-channel port-channel-number).
(Optional) Use [, | -] to specify a series or range of interfaces if they
were configured. This option is valid when monitoring only
received traffic. Enter a space before and after the comma; enter a
space before and after the hyphen.
(Optional) Specify the direction of traffic (both, rx, or tx) to no
longer monitor. If you do not specify a traffic direction, both
transmit and receive are disabled.
Step 3 end Return to privileged EXEC mode.
Step 4 show monitor [session session_number] Verify your entries.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.