IBM 12.1(22)EA6 - Manual (Page 358)

20-2
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 20 Configuring System Message Logging
Configuring System Message Logging
Configuring System Message Logging
These sections describe how to configure system message logging:
• System Log Message Format, page 20-2
• Default System Message Logging Configuration, page 20-3
• Disabling and Enabling Message Logging, page 20-4
• Setting the Message Display Destination Device, page 20-4
• Synchronizing Log Messages, page 20-6
• Enabling and Disabling Timestamps on Log Messages, page 20-7
• Enabling and Disabling Sequence Numbers in Log Messages, page 20-8
• Defining the Message Severity Level, page 20-8
• Limiting Syslog Messages Sent to the History Table and to SNMP, page 20-10
• Configuring UNIX Syslog Servers, page 20-10
System Log Message Format
System log messages can contain up to 80 characters and a percent sign (%), which follows the optional
sequence number or timestamp information, if configured. Messages appear in this format:
seq no:timestamp: %facility-severity-MNEMONIC:description
The part of the message preceding the percent sign depends on the setting of the service
sequence-numbers, service timestamps log datetime, service timestamps log datetime [localtime]
[msec] [show-timezone], or service timestamps log uptime global configuration command.
Table 20-1 describes the elements of syslog messages.
Table 20-1 System Log Message Elements
Element Description
seq no: Stamps log messages with a sequence number only if the service sequence-numbers global
configuration command is configured.
For more information, see the “Enabling and Disabling Sequence Numbers in Log Messages”
section on page 20-8 .
timestamp formats:
mm/dd hh:mm:ss
or
hh:mm:ss (short uptime)
or
d h (long uptime)
Date and time of the message or event. This information appears only if the service timestamps
log [datetime | log] global configuration command is configured.
For more information, see the “Enabling and Disabling Timestamps on Log Messages” section on
page 20-7 .
facility The facility to which the message refers (for example, SNMP, SYS, and so forth). For a list of
supported facilities, see
Table 20-4 on page 20-12 .
severity Single-digit code from 0 to 7 that is the severity of the message. For a description of the severity
levels, see
Table 20-3 on page 20-9 .