IBM 12.1(22)EA6 - Manual (Page 432)

23-24
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 23 Configuring QoS
Configuring Standard QoS
For more information about creating IP standard ACLs, see the “Guidelines for Applying ACLs to
Physical Interfaces” section on page 22-5 .
To delete an ACL, use the no access-list access-list-number global configuration command.
This example shows how to allow access for only those hosts on the two specified networks. The
wildcard bits apply to the host portions of the network addresses. Any host with a source address that
does not match the ACL statements is rejected.
Switch(config)# access-list 1 permit 192.5.255.0 0.0.0.255
Switch(config)# access-list 1 permit 36.0.0.0 0.0.0.255