IBM Print System QMS 1725E - Manual (Page 71)

If You Have Trouble
4-19 Connecting to an Ethernet Network
and in the Administration/Communications/Network 2/
CrownNet/Common/HW Address menu).
» Note: You can also send the hardware address of a UNIX system
through the BOOTP and RARP utilities.
If You Have Trouble
If you have trouble connecting and configuring your Ethernet inter-
face, check the following:
n
Is the printer connected to the network?
n
Is the printer plugged in, turned on, and correctly configured?
n
Do the printer start-up and status pages list the interface? Is the
configuration information correct?
n
Is the interface enabled?
n
Is the appropriate protocol (or protocols) enabled?
n
Are all printer and protocol addresses configured correctly?
For More Information
In addition to this chapter, the following documentation contains infor-
mation you may need when using the Ethernet interface:
n QMS CrownNet Interface System Administrator’s Guide—Pro-
vides detailed configuration and utility information.
n
QMS Crown Remote Console User’s Guide—Explains how to
use Remote Console to control printing from a workstation any-
where on the network.
n Your network documentation—Contains information on printing.