IBM Print System QMS 1725E - Manual (Page 63)

Configuring the Interface
4-11 Connecting to an Ethernet Network
2 Skip to “Configuring the Network,” later in this chapter.
LAN Manager/LAN Server
1 One unique printer name is broadcast to the network. Use
the Administration/Communications/Network 2/CrownNet/
Lan Manager/Printer Name menu to enter the name of the
printer.
» Note: The name can be up to 16 characters long.
Spaces and lowercase characters are not allowed. However, Underscore
characters (_) are allowed to simulate multiword names (for example,
PRODUCT_MKTG).
2 Skip to “Configuring the Network,” later in this chapter.
NetWare
If you want something other than the default settings, use the follow-
ing procedure to name the file and print servers. These names must
be unique.
» Note: In CrownAdmin, the printer shows up as
QMS- xxxx-Print-
System- hardwareaddress
, where
xxxx
is the printer model number
and
hardwareaddress
is the printer’s hardware address as found on
the printer start-up page.
1 In the Administration/Communications/Network 2/CrownNet/
NetWare/Config PServer/File Srv Name[1], File Srv Name[2],
and File Srv Name[3] menus, enter the name of the target file
server.
» Note: The three File Srv Name[x] menus allow you to identify 1 file server
with a name up to 48 characters long. (Up to 16 characters can be
entered in each of the three menus). You cannot use these three menus
to identify three file servers.
Spaces and lowercase characters are not allowed within file server
names. However, underscore characters (_) are allowed to simulate
multiword names (for example, PUBS_SERVER). At the printer control
panel only, a space must be used following the last character of the file
server name to end the name.