IBM Print System QMS 1725E - Manual (Page 70)

Configuring the Network
QMS 1725E Print System Getting Started 4-18
5 In the Print Queue Information menu select Queue Servers
and press Enter.
6 Press the Ins key to display the Queue Server Candidates
menu.
7 Select the appropriate print server name and press Enter.
8 Press Esc four times to display the Exit PCONSOLE menu.
9 Select Yes and press Enter to save your changes and exit
from PCONSOLE.
TCP/IP
1 Log on the UNIX system as root.
2 Edit the system host table by adding the following line to the
/etc/hosts file:
internetaddress hostname
where internetaddress is the Internet address of the printer
(Administration/Communications/Network 2/CrownNet/
TCPIP/Internet Address menu) and
hostname is the name of
the host.
3 If necessary, set the hardware address.
O Caution: We strongly recommend that you do not change the hardware
address.
If you’re working on a system other than a UNIX system, set
the hardware address through the printer control panel.
If you’re working on a UNIX system, send the hardware
address to the print server by typing
arp -s hostname hardwareaddress temp
↵
ping hostname
↵
where hostname is the name of the host and
hardwareaddress is the hardware address of the printer (in
the form
##.##.##.## as found on the printer start-up page