IBM Print System QMS 1725E - Manual (Page 58)

Installing the Software
QMS 1725E Print System Getting Started 4-6
3 Open an OS/2 window, and at the C> prompt, change to the
drive in which you inserted the CrownNet Manager disk (for
example,
a:
↵
).
4 At the drive prompt type
lsminst x: y:
↵
where x is the drive in which you inserted the CrownNet
Manager disk, and y is the drive on which CrownNet
Manager will be installed (for example, lsminst a: c:
↵
).
» Note: If you’ve previously installed the CrownNet Manager, you can use
lsminst x: y: /u
↵ to force installation of the upgraded
software.
The installation program creates and installs the software in
a directory named
y:\CROWN.
» Note: You can’t install the utilities by copying files from the disks. You
must run the installation program.
5 Remove the disk from the disk drive and store it in a safe
place.
6 To start the CrownNet Manager for OS/2 automatically each
time the print server is turned on, add the following com-
mands, in this order, at the end of the STARTUP.CMD file (but
before any @EXIT command):
set crownman=c:\crown
start c:\crown\crownman.exe -m
» Note: The -m option minimizes the CrownNet Manager window to an icon
after the program opens.
7 To start the CrownNet Manager now, open an OS/2 window
and type the following commands:
set crownman=c:\crown
↵
start c:\crown\crownman.exe
↵
The CrownNet Manager window appears.
8 To install specific ports, choose Install from the CrownNet
Manager window.