beautypg.com

Intel LAN+Modem56 PC Card PRO/100 User Manual

Page 97

background image

Windows 3.x/MS-DOS Installation 4-59

3 Turn computer power off and then on again (cold boot).
4 Start the Windows Terminal program in the Accessories group.

Select a COM port under the setting/communications options, click

OK to get back to the terminal screen. Change to modem command

mode and type AT, then press enter. If the modem responds with

OK, the trial configuration was correct.

5 In some cases an interrupt conflict will not be apparent until a

Windows mouse driver is loaded. It will then be necessary to cold

boot the machine, load the PRO/100 PC Card driver and re-start at

step 1. above.

C. Try disabling Card and Socket Services if they are enabled (see Item 2

of these Symptoms and Solutions).
D. If you are NOT using Card and Socket Services, try the following:

1 Verify the following entries in the Windows SYSTEM.INI file:

BOOT.

COMM.DRV=COMM.DRV

386ENH.

DEVICE=*VCD

You may need to remark out any *VCD.386 added by other

programs (IBMVCD.386, PCMVCD.386, SSVCD.386).

2 In Windows, go into the Control Panel, then Ports, and under the

Advanced options, set the selected COM port IOADDRESS and

INTERRUPT to default settings.

3 Exit Windows and turn computer off and on again (cold boot).
4 Start the Windows Terminal program in the Accessories group.

Select a COM port under the setting/communications options, click

OK to get back to the terminal screen. Change to modem command

mode and type AT, then press enter. If the modem responds with

OK, the trial configuration was correct.

5 In some cases an interrupt conflict will not be apparent until a

Windows mouse driver is loaded. It will then be necessary to cold

boot the machine, load the PRO/100 PC Card driver and re-start at

step 1. above.