Intel LAN+Modem56 PC Card PRO/100 - Manual (Page 47)

Windows 3.x/MS-DOS Installation 4-9
22 In LAN Manager System Service Connection Information window,
enter username and press Enter.
23 Enter the Windows directory path.
24 Press Enter to add the STARTNET.BAT file to your
AUTOEXEC.BAT file.
25 A PROTOCOL.INI file created by SETUP will display in edit
mode.
a Remove the semicolon at the beginning of the ni_irq line, as
follows:
Change the line
;NI_IRQ = [IRQ VALUE FROM STEP 5 OF THE FIRST PROCEDURE ABOVE]
to read
NI_IRQ = [IRQ VALUE FROM STEP 5 OF THE FIRST PROCEDURE ABOVE]
The ni_irq value must be the same as the interrupt value used for
the Intel adapter.
b Verify that the [M16BNDIS]` section has the following lines and
settings:
[M16BNDIS]
DRIVERNAME=INTEL$
26 Exit SETUP and reboot to start the network. (Some machines may
require a cold boot at this point—power the computer down and
back up again.)
FTP Software LANWatch
Packet and NDIS 2.0 Drivers
FTP Software’s LANWatch network monitor software can be installed
using Intel’s packet or NDIS 2.0 drivers. For information on which driver
is appropriate for your network environment, refer to the FTP LANWatch
documentation.
FTP Software LANWatch Packet Driver Installation
1 Run the Intel Installation Program from the Installation Disk.