Intel LAN+Modem56 PC Card PRO/100 - Manual (Page 51)

Windows 3.x/MS-DOS Installation 4-13
FTP PC/TCP 3.X with OnNet 1.1 with Windows 3.1
1 Run the Installation Program from Intel Disk 1, Installation Disk.
2 From the Select Network Operating System screen, choose FTP
PC/TCP.
3 Follow the prompts to complete the Intel installation.
4 Run the PC/TCP installation program OnNet 1.1.
5 When prompted, insert Intel Disk 2, Network Drivers Disk.
6 Follow prompts to complete the PC/TCP installation.
7a For an NDIS installation, reboot the PC.
7b For ODI installation, do not reboot. Continue with step 8.
Additional Steps for ODI Installation
If you are using an ODI driver, continue with the following steps:
8 Change to the directory into which PC/TCP was installed.
9 Use a text editor to change the file PCTCP.INI as follows:
• In the section PCTCP ifcust 0 change the line
INTERFACE-TYPE=NDIS
to read
INTERFACE-TYPE=PKTDRV
10 Save the file and exit the text editor.
11 Change to the C:\ (root) directory.
12 Use a text editor to modify the AUTOEXEC.BAT file as follows
(\PCTCP is the default installation directory):
• Move the line containing the STARTNET.BAT command or the
lines containing the network driver files to immediately above the
line
SET PCTCP=C:\PCTCP\PCTCP.INI
• Add the line
C:\PCTCP\ODIPKT
after the line
PCTCP=C:\PCTCP\PCTCP.INI
13 Save the file and exit the text editor.