IBM Tivoli and Cisco - Manual (Page 352)

334 Building a Network Access Control Solution with IBM Tivoli and Cisco Systems
4. The user just created should be seen under
List of Local Users
, as shown in
Figure 7-102.
Figure 7-102 List of local users
Configure Clean Access Agent
This section identifies rules and checks that will be applied to users that are
running a prototype interface especially designed to interoperate with the Tivoli
Security Compliance Manager client for the purpose of this book. NAC
Appliance 4.1, scheduled for release before the end of 2006, will contain a
feature called
Launch
that can be configured to trigger the Tivoli Security
Compliance Manager client. For information about establishing this feature in
NAC Appliance please review “NAC Appliance details” on page 455. To configure
the Clean Access Agent follow these steps:
1. Click Device Management
→
Clean Access
→
Clean Access Agent
→
Rules
→
New Check.