Intel MD566X User Manual

Page 54

56K V.92 Data, Fax, and Voice Chipset

Intel Confidential

Programmer’s Guide

&Yn

Select Stored Profile on Power-up: This command selects the particular
stored user profile from the NVRAM to be loaded into the active profile upon
modem power-up.

n = 0**

Select profile 0

n = 1

Select profile 1

&Zn=x

none

Store Telephone Number: This command stores a telephone number up to
30 digits (including dial modifiers) in the NVRAM. To dial the stored tele-
phone number, use the ATDS=n command. Use the

command to see the

stored telephone number.

n = 0–3

x = 0–9 A B C D # * T P R W @ , ! ;

%En

Auto-Retrain Control: This command controls whether the modem auto-
matically initiates a modem retrain whenever the received data signal quality
falls below a threshold that may affect data reliability. The value for ‘n’ is
stored in the NVRAM.

n = 0

Disabled

n = 1**

Enabled

%Gn

Rate Renegotiation: This command selects whether the modem automatically ini-
tiates a change to a higher speed or lower speed depending on received signal qual-
ity (that is, rate negotiation). The modem always responds to any rate change initi-
ated by the remote modem.

n = 0

Disabled

n = 1**

Enabled

Table 3-4.

Data Mode Command Descriptions (Continued)