Intel MD566X User Manual
Page 47
56K V.92 Data, Fax, and Voice Chipset
Programmer’s Guide
Intel Confidential
47
Ln
2
Speaker Volume Control: This command selects the modem’s speaker vol-
ume.
n = 0
Low speaker volume
n = 1**
Low speaker volume
n = 2
Medium speaker volume
n = 3
High speaker volume
Mn
1
Speaker Control: This command specifies when the speaker is turned on
and off.
n = 0
Speaker always off
n = 1**
Speaker on until carrier present
n = 2
Speaker always on
n = 3
Speaker off during dialing, and on until carrier
Nn
1
Select Data Rate Handshake: This command specifies whether the result-
ing modem-to-modem modulation can be different from the modulation spec-
ified in the
+MS=m
n = 0
When originating or answering, connect only at the data rates spec-
ified by the modulation.
n = 1**
When originating or answering, begin handshaking at the modula-
tion data rate. If the remote modem does not support the specified
modulation data rate, fall down in data rate or modulation to the
highest compatible data rate.
On
0
Go Online: This command causes the modem to return back to online data
mode from online command mode.
n = 0**
Returns the modem to data mode
n = 1
Begins an equalizer retrain sequence, then returns to data mode
P
none
Select Pulse Dialing:
This command configures the modem to use pulse dialing
next time the modem dials a telephone number.
Qn
0
Result Code Display Control: This command selects whether the modem
sends result codes to the DTE.
n = 0**
Result codes enabled
n = 1
Result codes disabled
Sn
none
Select an S-Register: This command selects the current S-register.
n = 0–37
Table 3-4.
Data Mode Command Descriptions (Continued)