Setting up logical adapter network properties, Xt section, Setting up – Interphase Tech iSPAN User Manual
Page 91: Logical adapter network properties
Chapter 5: Setting Up the NDIS Driver
iSPAN Serial WAN Adapter Users Guide
71
Setting Up Logical Adapter Network
Properties
After you add a new logical adapter or start the NDIS Driver
setup utility to configure an existing logical adapter, the NDIS
Driver Setup dialog box appears.
Figure 5-3. NDIS Adapter Properties Dialog Box
To set up the logical adapter network properties, do the
following:
1. If needed, start the NDIS Driver Setup utility from the
control panel, as described in
.
2. In the Adapter section of the NDIS Driver Setup dialog
box, click the Properties button.