Interphase Tech iSPAN User Manual
Page 70
Setting Up Network Protocol Properties
50
Interphase Corporation
To set up TCP/IP properties for the NDIS logical adapter, do
the following:
1. In the Adapter field, select Interphase 5535 NDIS
Adapter.
2. Select the Specify an IP address option.
N
OTE
You must specify an IP address. DHCP is not supported.
3. To assign an IP address and subnet mask to the new
logical NDIS adapter, do the following:
a. In the IP Address field, type a valid IP address.
b. In the Subnet Mask field, type a valid subnet mask.
These values depend on your network configuration. If
you do not know the exact IP address or subnet mask for
your configuration, ask your Network Administrator for
assistance.
4. Type the default gateway address in the Default
Gateway field.
This is an optional parameter that, if used, must
correspond to an NDIS driver WAN channel. (For
information about setting up NDIS driver WAN
channels, see
Setting Up Channels for Logical Adapters
5. If you want the system to act as a TCP/IP router, select
the Routing tab, and select the Enable IP Forwarding
check box.