MITSUBISHI ELECTRIC MOTION CONTROLLERS Q172DCPU - Manual (Page 97)

4 - 6
4 AUXILIARY AND APPLIED FUNCTIONS
(3) ON region setting
(a) The data range which makes the output device turn ON/OFF toward the
watch data.
(b) The following devices can be used as the ON Value and OFF Value of the
data range.
The data type of device/constant to be set is the same as the type of watch
data.
Item Device No. setting range
Data register D0 to D8191
Link register W0 to W1FFF
Motion register #0 to #7999
Multiple CPU area device U \G10000 to U \G (10000+p-1)
(Note-1)
Constant Hn/Kn
(Note-1) : "p" indicates the user setting area points of the Multiple CPU high speed
transmission area for the each CPU.
(4) Output enable/disable bit
(a) Set the status of output enable/disable bit when the limit switch output is
forbidden during operation.
1) The following control is exercised.
Output enable/disable bit Control description
Without setting
(always enable)
ON (enable)
Limit switch output is turned ON/OFF based on the ON
region setting (ON Value, OFF Value).
With setting
OFF (disable) Limit switch output is turned OFF.
(b) Usable devices
Item Device No. setting range
Input relay
(Note-1)
X0 to X1FFF
Output relay
(Note-2)
Y0 to Y1FFF
Internal relay M0 to M8191
Link relay B0 to B1FFF
Annunciator F0 to F2047
Special relay SM0 to SM1999
Multiple CPU area device U \G10000.0 to U \G (10000+p-1).F
(Note-3)
(Note-1) : The real input range(PX) is included.
(Note-2) : The real input range(PY) is included.
(Note-3) : "p" indicates the user setting area points of the Multiple CPU high speed
transmission area for the each CPU.