beautypg.com

Replacing the hot-swap backplanes, Replacing the – Gateway E-9425R User Manual

Page 55

background image

www.gateway.com

49

6

Slide the power cage (4) toward the front of the chassis to disengage the locking tabs,
then lift the power cage out of the chassis.

7

Place the new power cage into the chassis, aligning the cage with the locking tabs in the
chassis, then slide the power cage toward the back of the chassis to engage the locking
tabs.

8

Replace the screws you previously removed.

9

Replace the power distribution board by following the instructions in

“Replacing the

hot-swap backplanes” on page 49.

10

Reinstall the power supply modules by following the instructions in

“Replacing a power

supply module” on page 46

.

11

Follow the instructions in

“Closing the server case” on page 30

.

Replacing the hot-swap backplanes

To replace the hot-swap backplane:

1

Follow the instructions in

“Preventing static electricity discharge” on page 28

. Make sure

that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.

2

Unlock the bezel (if necessary) and remove it by pulling it straight off the front of the server.

3

Follow the instructions in

“Opening the server case” on page 29

.

4

Remove all of the hot-swap drive carriers from the server and make note of which bay
you remove each drive from. For instructions, see

“Removing and installing a hard drive”

on page 33

.

5

Remove the system fans and fan board by following the instructions in

“Replacing system

fans” on page 41

.

6

Disconnect all cables from the backplane.

7

Loosen the thumbscrew (1) on the backplane, then slide the backplane (2) toward the right
(facing the back of the chassis) until it disengages the locking tabs and lift it out of the
chassis.

Caution

The hot-swap backplane is not hot-swappable. Before removing or replacing the

backplane, you must first turn off the server and all peripheral devices attached to the
server, and remove the AC power cord(s) from the power supply or wall outlet.