Gateway 8450R - Manual (Page 85)

84 Replacing and Adding Internal Devices
7 Align the rails on the new power supply module with the grooves at the
top and bottom of the power supply and slide the power supply module
in.
8 Slide the module all of the way into the space until the clip at the top
clicks into place, then tighten the thumbscrew at the bottom of the power
supply module.
9 Replace the bezel.
Replacing the power supply
The redundant 350-W power supply provides all system power. If one of the
components of the power distribution hardware fails, you must replace the
entire power supply.
To replace the power supply:
1 Turn off the server and disconnect the power cord and all peripherals.
2 Remove the bezel and the front top panel. (See “Removing the bezel”
on page 27, “Removing the front top panel” on page 29, and “Preventing
static electricity discharge” on page 25.)
8506284.book Page 84 Thursday, July 13, 2000 11:43 AM