Gateway 8450R - Manual (Page 116)

Setting the system board jumpers 115
Password Clear jumper
The Password Clear jumper on the system board (pins 5 through 7 of jumper
J9F2) lets you delete the passwords. (See the figure on page 13 for the location
of the jumper.)
The following table shows the settings required to perform this task. Make
sure you turn off the server and unplug the power cord before moving the
jumper.
Mode Jumper
Setting Action When Set
Protect
Pins 5-6
Normal operation
Clear
Pins 6-7
Clears all passwords at bootup
Caution Moving the jumper while the power is on can damage your
server. Always turn off the server and unplug the power
cord(s) from the server before changing the jumper.
8506284.book Page 115 Thursday, July 13, 2000 11:43 AM