Gateway 8450R - Manual (Page 38)

Drives 37
To remove a hot-swap drive:
1 Follow the static electricity precautions in “Preventing static electricity
discharge” on page 25.
2 Use the SCSI control software to stop activity on the drive you need to
remove.
3 Open the bezel door as described in “Opening the bezel door” on page 27.
4 Pinch the grip of the drive carrier handle to release the clip at the top.
5 Swing the carrier handle down and pull the drive out of the drive cage.
Continue pulling until the drive is entirely out of the drive cage.
6 Place the drive on a static-free surface. If you are replacing the drive, see
“Installing a hot-swap drive” on page 38.
8506284.book Page 37 Thursday, July 13, 2000 11:43 AM