Replacing the ps/2 power supply – Gateway 7210 User Manual
Page 77
70
Replacing and Adding Internal Devices
Replacing the PS/2 power supply
The PS/2 power supply does not support fault tolerance or hot-swapping. If
the power supply fails, you must replace it.
To replace the PS/2 power supply:
1
Turn off the system and disconnect the power cord and all peripherals.
2
Open the case. (See “Opening the case” on page 23 and “Preventing static
electricity discharge” on page 22.)
3
Disconnect the power supply connectors from all internal devices,
including the 3.5-inch diskette drive, the CD drive, and all hard drives.
4
Disconnect the main power supply connector to the system board, by
pressing on the tab to release the connector, then gently pull the
connector from the board.
5
While supporting the power supply with one hand, remove the screws
securing the power supply to the back panel and the top panel.
8505945.book Page 70 Thursday, March 9, 2000 2:13 PM
- E-2300 (134 pages)
- E-4100 (144 pages)
- ALR 7300 (138 pages)
- E-4650 (134 pages)
- E-6300 (136 pages)
- E-9232T (96 pages)
- 610 (108 pages)
- ProfileTM 5 (292 pages)
- Profile 6 (130 pages)
- E SERIES E-6000 (190 pages)
- SZSL95IN0XXXXXXXX (132 pages)
- 8400 (34 pages)
- DX4800 (94 pages)
- GR380 F1 (17 pages)
- MAN FX510 (150 pages)
- GM5688E (140 pages)
- GR585 F1 (14 pages)
- 6400 (148 pages)
- GM5478 (2 pages)
- 7400 (156 pages)
- E-5250 (46 pages)
- FX6710 (1 page)
- E-9425R (118 pages)
- ALR 7200 (134 pages)
- FX542X (154 pages)
- 7250R (135 pages)
- 7250R (26 pages)
- DX430X (96 pages)
- 8450R (4 pages)
- 8450R (172 pages)
- 7450R (124 pages)
- E-5400 (130 pages)
- E-5200 (46 pages)
- PC (110 pages)
- GR160 F1 (14 pages)
- ALR 8300 (128 pages)
- eMachine 3 (96 pages)
- 9415 (188 pages)
- 980 (131 pages)
- 9210 (106 pages)
- E1400 (136 pages)
- FX542XT (94 pages)
- E3400 (126 pages)
- Media Center (28 pages)
- MT-6733 (3 pages)