beautypg.com

4 four-port 10 mb and 100mb mm fiber st modules, 5gigabit (1000mbps) port modules – GarrettCom 6K16V User Manual

Page 18

background image

Magnum 6K16V Managed Fiber Switch Installation and User Guide (01/04)

11

www GarrettCom com

.

.

2.2.4

Four-Port 10 Mb and 100Mb mm Fiber ST Modules

The 4-port @10Mb ST fiber modules behave the same as the 4@100Mb ST

fiber modules except for the 10Mb speed. For ports numbering, ports 1, 2, 5, 6 are
present, ports 3, 4. 7, 8 are not present. There is also a similar 100Mb fiber SC module.

The default setup on the 10Mb fiber module is half-duplex, which allows the

Magnum 6K16V Switch to connect to any 10Mb hub or media converter or almost any
other device with a 10Mb fiber Ethernet port. The default setting of the 100Mb module is
full duplex. User mode-control per port through the MNS “port settings” software is the
same as the other 6K16V modules.

The fiber ports support fiber cabling distances according to the 10BASE-FL

and 100BASE-FX standards, i.e., 2km distance for multi-mode fiber. (Single-mode for
up to greater distance may be available as a special order, request quote).

2.2.5

Gigabit (1000Mbps) port modules

The Magnum 6K16V can be configured

for Gigabit speed. Both slots may be Gigabit, and

modules for one or two Gb ports per slot are available The 6K16V Modules provide a

GBIC opening for insertion of industry-standard GBICs to provide Gb media flexibility.

GBIC models are available for both multi-mode and single-mode fiber connections, and

for Gb copper as well, with new models appearing in the marketplace often. The

1000Mbps RJ-45 module are compatible with the IEEE 802.3ab Gigabit standard

The 1000Mb Gigabit fiber-port modules on the Magnum 6K16V are normally

set (factory default) to operate in full-duplex mode for best fiber distance and

performance. The 1000Mbps SC fiber-optic module on the Gigabit -SX and Gigabit-LX

transceivers are compatible with the IEEE 802.3z Gigabit standards.

There are two LEDs for each Gigabit port. The Gigabit fiber port is fixed at

1000Mbps speed full-duplex mode at all times and has LEDs that indicate LK (Link

status) and ACT (receiving activity) on that port when lit.

2 6

T

LK

R

ACT
F/H

TX RX

LK

ACT
F/H

TX RX

LK

ACT
F/H

TX RX

LK

ACT
F/H

1 5