FUJITSU PRIMERGY RX600 S6 - Manual (Page 88)

88 Operating Manual RX600 S6
CSS components
©
c
og
ni
ta
s.
Ges
el
ls
ch
ft f
ü r T
e ch
ni
k-
D
ok
um
e
nt
a tio
n m
bH
201
1
P
fad:
C:
\P
rog
ra
m
m
e\
F
C
T
\ti
m
_a
pp
\ti
m
_l
o
ca
l\w
or
k\
P
ICH
OL
\O
B
J_
D
OK
U
-1
1 94
2-
00
1.
fm
8.1.1.1 Replacing a hot-plug power supply unit
Figure 14: Unlocking and removing the power supply unit
V
CAUTION!
When replacing a non-defective hot-plug power supply unit in a non-
redundant configuration, the server must be switched off first.
Ê
Remove the power cord from the cable clamp. You can losen the cable
clamp by opening the small locking lever.
Ê Remove the power cord from the installed power supply unit.
Ê Press the green release lever (1) and pull out the power supply unit in the
direction of the arrow (2). Grip the handle while pulling the power supply.
V
CAUTION!
Release your hands from lever (1) as soon as the power supply unit
has been pulled out a few centimeters.
Ê Completely remove the defective power supply unit from the slot.
V
CAUTION!
Never leave the slot for the power supply unit empty for more than
two minutes during operation. Otherwise, excessive temperatures
could damage system components.
/ 0