FUJITSU PRIMERGY RX600 S6 - Manual (Page 72)

72 Operating Manual RX600 S6
Starting up and operation
©
c
og
ni
ta
s.
Ges
el
ls
ch
ft f
ü r T
e ch
ni
k-
D
ok
um
e
nt
a tio
n m
bH
201
1
P
fad:
C:
\P
rog
ra
m
m
e\
F
C
T
\ti
m
_a
pp
\ti
m
_l
o
ca
l\w
or
k\
P
ICH
OL
\O
B
J_
D
OK
U
-1
1 93
9-
00
1.
fm
5.3 Configuring the server
This section contains information about configuring the server and installing the
operating system.
I
Make sure that the energy saving functions are disabled in the BIOS
Setup during server operation.
5.3.1 Configuring the SAS/SATA RAID controller card
The server comes with a SAS/SATA RAID controller with "MegaRAID
functionality". You can configure the SAS/SATA RAID controller either before or
during installation with the ServerView Installation Manager. Using the
ServerView Installation Manager is recommended.
I
A separate utility is available to the controller for MegaRAID
configuration. For further information, refer to the "SAS Software User’s
Guide" (on the ServerView Suite DVD 2 under Industry Standard Servers -
Expansion Cards - Storage Adapters - LSI Configuration Software).
Further information on modular RAID controllers is provided in the
"Modular RAID Controller Installation Guide" (on the ServerView Suite
DVD 2 under Industry Standard Servers - Expansion Cards - Storage Adapters
- LSI RAID / SCSI Controllers).
I
Descriptions of operating systems not covered in the controller manual
are provided in the corresponding readme files on the driver CDs.