FUJITSU PRIMERGY RX600 S6 - Manual (Page 50)

50 Operating Manual RX600 S6
Hardware installation
©
c
og
ni
ta
s.
Ges
el
ls
ch
ft f
ü r T
e ch
ni
k-
D
ok
um
e
nt
a tio
n m
bH
201
1
P
fad:
C:
\P
rog
ra
m
m
e\
F
C
T
\ti
m
_a
pp
\ti
m
_l
o
ca
l\w
or
k\
P
ICH
OL
\O
B
J_
D
OK
U
-1
1 93
8-
00
1.
fm
Installation requirements for AC non redundant configurations
For systems not requiring AC redundancy, the power supply subsystem can be
installed with up to 4 PSUs. The PSUs can be connected to a single or multiple
AC sources.
Three power supply modules are capable of handling the maximum power
requirements for a fully configured PRIMERGY RX600 S6 server system, which
include the following:
●
Four processors
● 1024 GB of memory
● Eleven PCIe add-in cards (including the SAS/SATA RAID controller card)
● Eight hard disk drives and/or solid state disks
● One optical drive
● One tape drive
The hot swap feature allows the user to replace a failed power supply module
without affecting the system functionality.
PSU Configuration Max. DC Loading DC Redundancy
1+1 (2 PSUs) 830W Yes
2+1 (3 PSUs) 1580W Yes
3+1 (4 PSUs) 2320W Yes
Table 3: Maximum DC Loading Requirements