2 connecting the power cord, Connecting the power cord, 54 operating manual – FUJITSU PRIMERGY RX600 S6 User Manual
Page 54: Hardware installation, Rx600 s6, Figure 6: cable clamps to secure the power cords

54
Operating Manual
RX600
S6
Hardware installation
©
c
og
ni
ta
s.
Ges
el
ls
ch
ft f
ü
r T
e
ch
ni
k-
D
ok
um
e
nt
a
tio
n m
bH
201
1
P
fad:
C:
\P
rog
ra
m
m
e\
F
C
T
\ti
m
_a
pp
\ti
m
_l
o
ca
l\w
or
k\
P
ICH
OL
\O
B
J_
D
OK
U
-1
1
93
8-
00
1.
fm
4.4.2
Connecting the power cord
Ê
Connect the power cord to the server power supply unit.
Ê
Secure the power cords in the cable clamps so the insulated connectors
cannot be disconnected from the server accidentally.
Figure 6: Cable clamps to secure the power cords
Ê
Thread the cable through the cable clamp as shown in
Ê
Pull the cable clamp tight to secure the power cord.
Now the insulated connector cannot be disconnected from the server
accidentally.
I
You can loosen the cable clamp by opening the small locking lever.
Ê
Connect the mains plug to a grounded mains outlet in the in-house power
supply network or a power outlet of the socket strip in the rack (see Technical
Manual for the rack).